Electric impact wrench 3/4 “. Power 1100W, 800 Nm. Supplied with 24 mm, 30 mm, 32 mm, 36 mm caps. Length of the power cord is 4 meters, all in a handy case.
Purpose / use
Impact wrench is an ordinary power tool, II insulation class, designed to unscrew and tighten nuts and bolts. No electrical supply is required to have a pneumatic system to operate the key.
How to use
Correct, reliable and safe operation of the tool depends on proper operation. The key is delivered in a complete state and does not require assembly. The socket wrenches are supplied with the key. Before screwing in the screw or nut with a socket wrench, manually screw in the screw or nut on the thread (at least two turns). Make sure that the size of the spanner is well matched to the unscrewed or tightened element. Poorly sized sizes can damage both the key and the nut or bolt. Insert the socket wrench onto the nut or screw head. Press and hold the switch in the position corresponding to the desired direction of rotation. In the case of tightening, press and hold the switch in position F, while in the case of unscrewing in position R. In case of tightening, after reaching the maximum torque, the overload clutch will operate and the drive will be disconnected. Release the switch and wait for the engine to stop completely. If unscrewing, check that the tightening torque does not exceed the maximum torque of the wrench. In this case the overload clutch will also work and it may not be possible to unscrew the nut. After unscrewing, release the pressure on the switch and wait for the engine to stop completely. After finishing work, disconnect the tool from the power supply and proceed with maintenance.
Contents of the package
STHOR electric impact wrench, impact sockets 24 mm, 30 mm, 32 mm, 36 mm. Power cord length 4 meters.
Practical suitcase
3/4″ 1100W/ 800NM, VOLTAGE POWER 230V, RATED FREQUENCY: 50HZ, RATED INPUT POWER 1100W, NO LOAD SPEED: 2200 RPM, TORQUE: 450NM, 3/4″ SQUARE CONNECTOR, 4PCS SOCKETS: 24MM, 30MM, 32MM, 36MM, CABLE LENGHT 400CM (H07RN-F 2X1MM)
